Steamer Trunk Black Metal Lid Banding

Steel dust banding is typically used around the bottom edge of the trunk lid, helps to keep dust out of the trunk. It can also be used as strapping to run across the lid or up the front of the trunk.

This banding is black steel, fairly easy to bend around corners, and is sold in three widths: 5/8 inch, 3/4 inch, or 1-1/4 inches wide. Thickness is 0.031″.  The 5/8″ and 3/4″ banding are $5.00 per foot.  The 1-1/4″ banding is $6.00 per foot.  Shipping and handling are included for destinations in the USA.  Please look at all of the photos:  the pen is touching edge banding – that’s what we’re selling here.

This is not the same thing as the thin metal that runs up the corners of your trunk – this only is used on the lid or face of most trunks. If you need thin metal to replace the old stuff on the corners of your trunk we recommend that you take a look at our brass sheet or black corner metal.

Again, this metal right here is for the bottom edge of the trunk lid only. Sold per foot, and only per foot.
Please measure carefully – Dust Banding MAY NOT BE RETURNED because we cut it to the number of running feet you request.

Note: See the nice 90-degree bend in the banding shown in the last photo? You too can make sharp, snappy corners
like this – just clamp the banding in a vise, bend by hand and then tap down with a hammer until you have a right angle.

Please measure carefully – Dust Banding MAY NOT BE RETURNED